Headbanging 2009

]]> http://www.skr-home.de/wp/2009/09/07/headbanging-2009/feed/ 0 http://www.skr-home.de/wp/2008/09/07/headbanging-2008-in-finsterwalde-is-over%e2%80%a6/ http://www.skr-home.de/wp/2008/09/07/headbanging-2008-in-finsterwalde-is-over%e2%80%a6/#comments Sun, 07 Sep 2008 19:01:31 +0000 failure http://www.skr-home.de/wp/?p=31 After returning home from the Headbanging / Old style meeting in Finsterwalde you can find pictures in the gallery.  This way to the pictures of 2008.

Headbanging 2008

Things I used:

• an original smart interior light module (will not be damaged!)
• a breadboard in “euro”-format
• 15 Superflux – LEDs (3.1V, 60mA)
• 5 resistors, 75 Ohm, 0.6 W
• a screwing terminal for two wires
• some wires
• later on: white acrylic paint

The schematics:

How I did it:

1. open the original light module and remove the bulb
2. cut and shape the breadboard so that it fits easy into the base of the original light (the white part)
   
3. two cutouts will be needed for the original contacts, otherwise trim down the contacts, but this will damage the original module!
   
4. place and solder the LEDs
   
5. place the resistors on the bottom side of the breadboard in order to make them invisible
   
6. connect the positive ends to the + terminal contact
7. connect the negative ends to the – terminal contact
8. solder a wire to each of the original light-module’s contacts, but solder below the holes that normally fix the bulb, so the module remains usable with a bulb
   
9. fix the breadboard with doublesided tape and connect the two supply wires to the terminal
   
10. Install the original lamp cover and….
    
11. enjoy!
12. PS: Later on I painted the top of the board with white acrylic paint (two layers), it just looks nicer if the light is turned off, the board’s own color will not shine through the cover. A picture may follow in the future…
13. PPS: A nice add-on is a white LED replacement for the interior light switch.